优化端点条件的平面二次均匀B样条插值曲线

在利用反求法构造B样条插值曲线时，往往需要选取端点条件。 因此，可对端点条件进行优化选取，使得构造的B样条插值曲线满足特定要求。提出了一种利用曲线内能极小选取平面二次均匀B样条插值曲线端点条件的算法。首先给出了二次均匀B样条插值曲线分控制顶点与首个控制顶点（即端点条件）的递推关系式；然后给出了利用曲线内能极小优化选取首个控制顶点的算法，证明了利用该算法构造的C¹连续二次均匀B样条插值曲线为保形插值，并通过数值算例证明了算法的有效性；最后，为便于实际应用，基于MATLAB平台设计了算法所对应的图形用户界面，用户通过简单的操作即可获得光顺的C¹连续二次均匀B样条保形插值曲线。     

双曲冷却塔塔筒水平地震响应分析

为明确冷却塔在水平地震下的内力环向分布特征及内在原因,同时探究不同地震波时程与规范反应谱所得内力差异的原因,以某大型双曲冷却塔为例,在动力特性分析的基础上,通过反应谱方法和时程方法的水平地震响应计算及对比分析,对上述两个问题进行了研究。研究表明:由于仅侧弯振型对水平地震有贡献,而塔筒的侧弯振型和实际响应均表现为整体侧倾并伴随微弱的截面“流动”变形,这也使塔筒各内力的环向分布分别呈现正弦、余弦分布特征;其整体侧倾可类比于悬臂杆结构,塔筒子午向轴力FY、子午向弯矩MY、剪力FXY和扭矩MXY的环向分布可借助悬臂杆侧倾时截面正应力和剪应力分布来解释;而截面“流动”变形则决定了环向轴力FX和环向弯矩MX的环向分布;整体侧移显著而截面变形极小也使FY和FXY的幅值在塔筒中下部明显大于FX;由于冷却塔第1阶侧弯振型在水平地震响应中往往起绝对主导作用,因此可先对所选地震波计算得到其反应谱,对比第1阶侧弯振型周期对应的水平地震影响系数α值,即可初步推断不同时程及规范反应谱方法所得结果的大小关系。     

A new endocytic model based on the co-rotational grid method

Endocytosis plays important roles in many cellular physiological processes, such as metabolism and immune. Many theoretical models have been proposed to study the endocytic process, but little has considered the tensile deformation of the membrane and the actin forces. In this paper, a new endocytic model is proposed based on the co-rotational grid method. Our model gives a direct estimation of the in-plane strain of the plasma membrane and provides a basis for the calculation of further scission process of the vesicle. The results fit well with experimental data in the literature. Moreover, it is suggested that the active forces of actin at the endocytic site is the main mechanism driving the invagination of the plasma membrane.     

Stimuli-Responsive Purely Organic Room-Temperature Phosphorescence Materials

This Minireview summarizes the recent progress of stimuli-responsive purely organic phosphorescence materials. Organic phosphorescence is closely related to the intermolecular interactions, because such interactions are beneficial to promote spin orbital coupling (SOC) and boost intersystem cross (ISC) efficiency and finally are conducive to satisfactory phosphorescence. It is found that the intermolecular interactions, which are essential for organic phosphorescence, are easily disturbed by external stimuli such as mechanical force, photon, acid, chemical vapor, leading to the luminescence change. According to this principle, various purely organic phosphorescence materials sensitive to external stimuli have been developed. This Minireview categorizes reported stimuli-responsive purely organic phosphorescence materials on the basis of different stimuli, including mechanochromism, mechanoluminescence, photoactivity, acid-responsiveness and other stimuli. Some prospective strategies for constructing stimuli-responsive purely organic phosphorescence molecules are provided.     

Establishment and validation of an SIL-IS LC–MS/MS method for the determination of ibuprofen in human plasma and its pharmacokinetic study

In this work, we developed and validated a highly sensitive, rapid and stable LC–MS/MS method for the determination of ibuprofen in human plasma with ibuprofen-d3 as a stable isotopically labeled internal standard (SIL-IS). Human plasma samples were prepared by one-step protein precipitation. The chromatographic separation was achieved on a Poroshell 120 EC-C₁₈ (2.1 × 50 mm, 2.7 μm). Aqueous solution (containing 0.05% acetic acid and 5 mm NH₄Ac) and methanol were selected as the mobile phase with gradient elution. An electrospray ionization source was applied and operated in negative ion mode. Multiple reaction monitoring mode was used for quantification using target fragment ions m/z 205.0 → 161.1 for ibuprofen and m/z 208.0 → 164.0 for SIL-IS, respectively. This method exhibited a linear range of 0.05–36 μg/ml for ibuprofen with correlation coefficient >0.99. Mean recoveries of ibuprofen in human plasma ranged from 78.4 to 80.9%. The RSD of intra- and inter-day precision were both < 5%. The accuracy was between 88.2 and 103.67%. The matrix effect was negligible in human plasma, including lipidemia and hemolytic plasma. A simple, efficient and accurate LC–MS/MS method was successfully established and applied to a pharmacokinetic study in healthy Chinese volunteers after a single oral administration of ibuprofen granules.     

Internal plasticization of poly(vinyl) chloride using glutamic acid as a branched linker to incorporate four plasticizers per anchor point

Internal plasticization of polyvinyl chloride (PVC) using thermal azide‐alkyne Huisgen dipolar cycloaddition between azidized PVC and electron‐poor acetylenediamides incorporating a branched glutamic acid linker resulted in incorporation of four plasticizing moieties per attachment point on the polymer chain. A systematic study incorporating either alkyl or polyethylene glycol esters provided materials with varying degrees of plasticization, with depressed T_g values ranging from ?1 °C to 62 °C. Three interesting trends were observed. First, T_g values of PVC bearing various internal plasticizers were shown to decrease with increasing chain length of the plasticizing ester. Second, branched internal plasticizers bearing triethylene glycol chains had lower T_g values compared to those with similar length long‐chain alkyl groups. Finally, thermogravimetric analysis of these internally plasticized PVC samples revealed that these branched internal plasticizers bearing alkyl chains are more thermally stable than similarity branched plasticizers bearing triethylene glycol units. These internal tetra‐plasticizers were synthesized and attached to PVC‐azide in three simple synthetic steps. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019 , 57, 1821–1835     

The thermophysical properties of low‐temperature Pb plasma

The thermophysical properties of low‐temperature Pb plasma are calculated at temperatures 10–100 kK and densities below 0.2 of the solid‐state value. The thermodynamic values (pressure and internal energy) and transport coefficients (electrical conductivity, thermal conductivity, and thermal power) are considered. The plasma composition and thermodynamic parameters are obtained within the chemical approach, namely by means of the solution of the corresponding system of the coupled mass action law equations. Atom ionization up to +4 is taken into consideration. The electronic transport coefficients are calculated within the relaxation time approximation. The results obtained by means of the present model are compared with the available data of other models and experiments.     

On the Effect of the Various Assumptions and Approximations used in Molecular Simulations on the Properties of Bio-Molecular Systems: Overview and Perspective on Issues

Computer simulations of molecular systems enable structure-energy-function relationships of molecular processes to be described at the sub-atomic, atomic, supra-atomic or supra-molecular level and plays an increasingly important role in chemistry, biology and physics. To interpret the results of such simulations appropriately, the degree of uncertainty and potential errors affecting the calculated properties must be considered. Uncertainty and errors arise from (1) assumptions underlying the molecular model, force field and simulation algorithms, (2) approximations implicit in the interatomic interaction function (force field), or when integrating the equations of motion, (3) the chosen values of the parameters that determine the accuracy of the approximations used, and (4) the nature of the system and the property of interest. In this overview, advantages and shortcomings of assumptions and approximations commonly used when simulating bio-molecular systems are considered. What the developers of bio-molecular force fields and simulation software can do to facilitate and broaden research involving bio-molecular simulations is also discussed.